Uniden DSS 2405 - Manual (Page 6)

YOU NEED TO REGISTER THE DSS2405 TO THE MAIN BASE
BEFORE USE!
1 After placing the batteries in the handset, charge for 10
minutes. Then remove the handset from the charger and
place it in the main base (DSS2415, DSS2455, or DSS2465).
2 Registration starts automatically. While registering, “Handset
Registering” appears in the display.
3 When the registration is complete, “Registration
Complete” appears in the display.
If the registration fails, “Registration Failed” appears in the
display. Try the above steps again.
4 Once registration is complete, place the handset back in
the charger for 17 to 20 hours to ensure the batteries are
fully charged.
• An extra handset can be registered when the main base
is in the standby mode.
• In some cases you may need to attempt registration a
few times.
Register the Handset
Cleaning the battery charging contacts
To maintain a good charge, it is
important to clean the charging contacts
on both the handset and the charger
once a month. Use a dry cloth or pencil
eraser to clean.
contacts
– 5 –
DSS2415
Main Base
DSS2455/2465
Main Base
Charger
UU827BH ENG (DSS2405) 8/6/03 11:07 AM Page 5