Important safety instructions, Before you begin – Thermador CIT30 User Manual
Page 3
4
d
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
THIS APPLIANCE HAS TO BE INSTALLED BY A QUALIFIED TECHNICIAN.
LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION IS
COMPLETE.
SAVE FOR THE LOCAL INSPECTOR'S USE.
dWARNING: If the information in this manual is not followed exactly, fire or shock
may result causing property damage or personal injury.
dWARNING: Do not repair or replace any part of the appliance unless specifically
recommended in the manuals. Improper installation, adjustment, alteration, service
or maintenance can cause injury or property damage. Refer to this manual. For
assistance or additional information, consult a qualified installer, service agency, or
manufacturer.
Have the installer show you the location of the circuit breaker or fuse. Mark it for
easy reference.
Be sure your appliance is properly installed and grounded by a qualified technician.
Never modify or alter the construction of the appliance. For example, do not remove
leveling legs, panels, wire covers or anti-tip brackets/screws
Remove all tape and packaging before using the appliance. Destroy de packaging
after unpacking the appliance. Never allow children to play with packaging material.
Hidden surfaces may have sharp edges. Use caution when reaching behind or
under appliance.
Before you plug in an electrical cord, be sure all controls are in the OFF position.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet
storage space located above the surface units should be avoided. If cabinet storage
is to be provided, the risk can be reduced by installing a range hood that projects
horizontally a minimum of 5 inches (12.7 cm) beyond the bottom of the cabinet.
This appliance has been tested in accordance with ANSI/UL 858 Standard for
Safety for Household Electric Ranges and CAN/CSA-22.2 No.61 National Standard
of Canada for Household Cooking Ranges. It is the responsibility of the owner and
installer to determine if additional requirements and standards apply in specific
installations.
Before you begin
1.
Phillips head screwdriver
2.
Pencil
3.
Drill with 1/4 bit
4.
Jigsaw
5.
Tape measure
IMPORTANT :
INSTALLER:
IMPORTANT:
Important safety
instruction
Equipment and usage safety
requirements
Tools and parts needed