Toshiba RBC-AMS41E - Manual (Page 11)

GRUPAd.o.o.
10
Scheduled operations
• Scheduled operations for a 1-week period can be
performed using this remote controller.
• Eight (01 to 08) operations for each day of the week
can be set in a scheduled operation program (item
settings).
– The following items can be set in a program:
a. Operation time
b. Operation start/stop
c. Operation mode
d. Temperature setting (frost protection)
e. Restriction on button operations
f. Save operation
• With a scheduled operation, the air conditioner is
operated at the set operation time according to the
program which has been set.
• The operation time can be set in 1-minute increments.
* Restriction on button operations
This function cancels the button operations while a
scheduled operation is being executed. To use this
function, refer to the “Selecting the remote controller
functions” section and change the settings before
proceeding with the program settings described
below. The initial (factory) setting calls for no
restriction on the button operations.
* Save operation
The save operation function is not provided for
some models and systems. To find out whether the
function is provided, consult your dealer or a
contractor with specialized experience.
* Concerning the “Continue xx” setting
The “Continue” setting can be established for the
operation start/stop, operation mode and
temperature setting items. This setting causes the
current operation modes of the indoor units to be
continued.
* “Continue” is set on the initial screen for each item
of each program number so in the example of the
operation given above there is no need to input
anything for the operation start/stop and operation
mode items.
* This function does not work if the “timer operation
function” or “no timer function” has been selected by
following the steps set forth in the “Selecting the
remote controller functions” section.
• Perform the steps below to set up a scheduled
operation program (item settings).
* Programs can be set up whether the air conditioner
is running or shut down.
* While these steps are being taken, an air
conditioner which is operating continues to operate.
1 Push the button (46).
• The display transfers to the program input screen.
• The entire LCD screen starts blinking.
2 Push the button (45).
• Repeatedly push the button to move the day arrow
to the position above the day of the week when
the scheduled operation is to be executed.
3 Push the button (42).
• Set the day of the week when the scheduled
operation is to be executed.
• The days of the week display and the day arrow
stop blinking and light up.
4 Push the button (37).
• Each time the button is pushed, the number on the
numeric display changes in the following
sequence.
• Stop pushing the button when the number to be
programmed blinks on the display.
* For the items inside the square parentheses,
refer to the “Editing the operation programs”
section.
5 Push the button (42).
• The program number on the numeric display stops
blinking and lights up.
6 Push the TIME and buttons (40).
• Set the operation time. This time must be input.
• The steps taken are the same as for setting the
clock.
* After setting the time, there is no need to push
the button (42). All the items will be entered
together in step 8.
How to set up the operation programs
MB FRIGO Grupa d.o.o., Bani 81, 10010 Zagreb, www.toshiba.hr, e-mail: [email protected]