Tiger Products Co., Ltd JD 5065 / 5085 - 5105M - Manual (Page 100)

MAINTENANCE
SIDE ROTARY Maintenance Section 4-4
© 2012 Alamo Group Inc.
MAINTENANCE
REGULAR MAINTENANCE
The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour
meter to determine when regular servicing is required.
Daily or Every 8 Hours
ITEM SERVICE COMMENTS
Drive Shaft Yoke, U-Joint Grease Grease as instructed in
& Stub Shaft detailed Maintenance Section
Pump Drive Shaft Check and Lube Insure drive shaft end play
Crankshaft Adapter Check rubber grommets Replace grommets if damaged
or missing
Pivot Points Lubricate Inject grease until it appears at end
Hydraulic Fittings Check for leaks Tighten when needed.
Do Not use hands to check for leaks.
See Maintenance Precautions
Knives Check Inspect for missing or damaged
knives,change or sharpen as needed
Spindle mounting bolts Check 3/4” x 2” torque to 331ft./lbs.
(spindle to deck)
Knife mounting bolts Check Pre-lubricate threads, then
(knife to disk) torque to 800 ft. lbs.
Disk mounting bolts Check 5/8” X 1-3/4” bolt torque to
(disk to spindle) 204 dry or 184 oiled ft. lbs.
Belts Check/Adjust Check if broken, tighten as required
Main Frame and Deck Check Retorque bolts to torque
specifications in this section
Hydraulic Fluid Level Check Add if required per
fluid recommendations