Texas Instruments bq24010/2 - Manual (Page 9)

2-1 Test Summary
Test Summary
This chapter shows the test setups used and the tests performed in evaluating
the EVM.
Setup : The bq24010/2 EVM board requires a 5-VDC, 1-A power source to
provide input power and a single-cell Li-Ion or Li-Pol battery pack. The test set-
up connections and jumper setting selections are configured for a stand-alone
evaluation but can be changed to interface with external hardware, such as a
microcontroller.
Topic Page
2.1 I/O and Jumper Connecations 2-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Test Procedure 2-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2