Technicolor - Thomson DPL590 - Manual (Page 16)

Operating Your Receiver
EN
13
Switching the unit on and off
• To switch on the receiver, press the ON/ECO button
on the main unit once, or the button on the
remote control.
• Standby: when the receiver is in tuner mode, press
the ON/ECO button once to enter standby
mode.
On the remote control, press the button twice
within 2 seconds if the receiver is not in Tuner source
mode to enter standby mode.
To avoid entering standby mode when powering up
the unit, do not press the
button twice within 2
seconds.
• The receiver draws a small amount of electricity when
in standby mode. Unplugging the unit from the wall
socket will stop the draw.
Selection of source
When one of the source button is pressed, the input
corresponding to the name will be activated.
The receiver acts as a switching device between all the
sources that are plugged into it.
Example 1:
If you have connected a DVD player to the DVD input
on the receiver, press the SOURCE buttons on the
main unit repeatedly until DVD is selected or press
DVD•6CH on the remote control to receive the sounds
and images transmitted by the DVD.
Example 2:
Based on the example 1, the DVD is playing , if a VCR
is connected to the VCR input of the receiver, press
the SOURCE buttons on the main unit repeatedly
until VCR is selected or press AUX 1 (VCR) on the
remote control. The sound from the VCR source will
replace the DVD.
DPL590 EN 12/16/04 3:58 PM Page 17