Toshiba CN36Z71 - Manual (Page 19)

19
Ref
er
ence
Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V
’s
F
eatur
es
Appendix
Index
1 2 3
4 5 6
7 8 9
ENT 100 0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO MUTE
CH RTN
STROBE
EXIT
LIGHT
STOP SOURCE
ADV/
PIP CH
ADV/
PIP CH
FAV FAV
PLAY PIP
REC TV/VCR REW FF
STILL LOCATE SWAP
FAVORITE
MENU/
PREVIEW
ENTER
TV
CABLE
VCR
AUX
EXIT
Channel yz
MENU
yzx •
Adding channels to the TV’s memory
Your TV will stop on specific channels that are stored in the TV’s
channel memory when you press Channel
y or z. Use the steps
below to set all active channels in your area automatically.
Programming channels automatically
Your TV can automatically detect all active channels and store them
in its memory. After the TV has stored the channels in its memory,
you can erase channels or add your favorite channels. If you use both
ANT-1 and ANT-2 terminals, you must program channels for each
input source.
To add channels:
1. Press MENU, then press x or • until the SET UP menu
appears.
2. Press z or y until the TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use.
START
PUSH
CH PROGRAM
ADD / ERASE
ANT 1 / 2
T V / CAB L E
SET UP C.CAPTION AUDIO PREMIUM
To end push EXIT
PICTURE
L ANGUAGE
PREFERENCE
ANT1
English
TV
START
PUSH
Add
Cable
T IMER / CLOCK
CYCLONE
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press z to select CH PROGRAM.
5. Press x or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
“Programming Now Please Wait” appears.
6. When channel programming is complete, the message
“Completed (channel or cable number)” appears.
7. Press Channel y or z to view the programmed channels.