Transition Networks CPSMP-120 - Manual

User’s Guide
CPSMP-120
AC Power Supply Module
• PointSystem™
• CPSMC13xx-100 Accessory
The Transition Networks CPSMP-120
power supply is an AC slide-in-module
that provides optional, redundant
power to the CPSMC13xx-100
PointSystem™ 13-slot chassis and any
installed media converter slide-in-
modules and management modules.
The figure below illustrates the components of the CPSMP-120 power supply:
• An On/Off switch that, when set to “I”, allows the power supply module
to supply power to the chassis, and any installed modules.
• A panel fastener screw that secures the power supply module to the
chassis.
• A power LED indicator.
• A handle for installing and removing the power supply module to/from
the chassis.
• A fuse installed in a fuse holder.
• An external power connector that supplies power from a standard AC
wall outlet.
I 0
I 0
Power LED
On/Off Switch
Fuse Holder
Panel Fastener Screw
Handle
External Power Connector
Install the CPSMP-120 . . . . . . . . .3
Connect to External Power . . . . . .4
Replace the CPSMP-120 . . . . . . . .5
Replace the Fuse . . . . . . . . . . . . .7
Technical Specifications . . . . . . . .8
Troubleshooting . . . . . . . . . . . . . .9
Compliance Information . . . . . . .11