Toshiba SD-480EKE - Manual (Page 35)

35
Function setup
4) Press “8888” using number buttons. (Please note, this
is presetting password of this unit). Then press ENTER.
Press ENTER again to list the parental level.
Enter Password:
Set Password
Parental control : 8. Adult
The parental lock level is equivalent to the following
ratings:
Level 1: Kid Safe
Level 2: G
Level 3: PG
Level 4: PG-13
5) Press / to select the rating from 1 to 8. Rating one
(1) has the most restrictions while rating eight (8) can
virtually playback all DVD software.
6) Press OPEN/CLOSE button to activate the Parental
Level setting.
If the DVD has been designed to temporarily cancel the
Parental Level, the screen will change depending on which
disc is played. If you select “YES” with the ENTER
button, “Enter Password” screen will appear. Input the 4-
digit password as you have set then followed by ENTER
button and playback will start. If “NO” is selected, press
the OPEN/CLOSE to remove the disc.
Notes
• If you input a wrong password, press CLEAR button
and re-enter your 4-digit password again.
• You cannot play DVDs rated higher than the level you
selected unless you cancel the parental lock function.
Parental Control
DVDs equipped with the password function are rated
according to their content. The contents allowed by a
parental lock level and the way a DVD can be controlled
may vary from disc to disc.
For example, if the disc allowed, you could edit out violent
scenes unsuitable for children and replace them with more
suitable scenes, or you could lock out playback of the
disc altogether.
• DVDs may or may not respond to the parental lock
settings. This is not a defect in the DVD player. Make
sure this function works with your DVDs.
1) Press SETUP button.
2) Press / to select Rating.
3) Press button to select Parental control, then press
ENTER button. “Enter Password” screen will appear.
DVD
Level 5: PG-R
Level 6: R
Level 7: NC-17
Level 8: Adult
Night Mode
Night mode is equivalent to Dynamic Range Compress.
When it is On, it reduces the variations between loud and
soft sounds in audio output. You can still hear softer sounds
and dialog even in very low volume.
1) Press SETUP button.
2) Press / button to select Audio.
3) Press button, then use the / button to select
Night Mode.
4) Press ENTER button, then use the / button to
select the On or Off mode.
5) Press ENTER button.
6) Press SETUP button to exit the menu.
Note
Night mode is Dynamic Range Control (DRC) option for
analogue audio output.
: PCM
Off
On
Off
PCM
Bitstream
Parental control : 8. Adult
Set Password
Rating
Bitstream: Disc audio raw data will be output. Select
“Bitstream” if your amplifier supports “DTS”.
Off: To disable Digital Output.
Notes
• When you make a connection to a TV, Dolby Surround
Pro Logic or stereo system via the analogue audio jacks,
select “PCM” or “Bitstream”.
• If this DVD player is connected to a TV using HDMI,
make sure to select “PCM”.