Topcom Butler 2800 - Manual (Page 6)

6 Topcom Butler 2800
Topcom Butler 2800
• Insert 2 rechargeable batteries (AAA) inside the battery compartment of the handset..
Put the handset on the base unit. The red Charge LED will lit as long as the handset is on the base.
Charge the handset for a period of 24 hours before using the handset for the first time. To extend the battery life time,
discharge the batteries completely from time to time. As soon as the handset emits a warning tone or when the battery
icon
is empty, you have to put it back on the base unit for charging.
4. BATTERY LOW INDICATION
When the battery is empty, the handset no longer carries out operations. When a battery is completely empty and you
have put the handset on the base unit for a short period of time, the Battery symbol will appear to be fully charged but
this is actually not the case. The battery capacity will decrease rapidly. We advise you to put the handset on the base
unit for 12 hrs so that it can be recharged completely.
• Full battery
• Empty battery
When you are in the middle of a conversation and the battery is almost empty, the handset will emit a warning signal.
Place the handset on the base unit to charge.
5. OPERATION
5.1 OUTGOING CALLS
5.1.1 Making a phone call
•
Press the Line button . You will hear the dial tone.
• Enter the desired telephone number.
• Press the Line button when you want to terminate the call.
5.1.2 Call setup with dial preparation
•
Enter the desired telephone number. An incorrect number can be corrected by means of the Mute button . When
you haven’t pressed a button for 10 seconds, the number you’ve already entered will disappear and the handset
returns to standby mode.
• Press the Line button . The number will be dialled automatically.
• Press the Line button when you want to terminate the call.
+ -
- +
H L _ B 2 8 0 0 . b o o k Page 6 Friday, August 29, 2003 1:16 PM