Topcom Butler 2800 User Manual
Page 10
10
Topcom Butler 2800
Topcom Butler 2800
•
Press and hold the
and
key for 3 sec.
•
The following will appear on the display:
•
Enter the number of the base unit you would like to subscribe the handset to (1-4)
•
The unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
•
Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for the base.
•
When the handset is registered, it will show ‘HS’ followed by the handset number.
7.2 SUBSCRIBING A TOPCOM BUTLER 300 DECT GAP HEADSET
Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the base unit starts to blink
quickly. The line/charge indicator will blink quickly for one minute. During this minute, the base unit is in subscribing
mode and you must do the following to subscribe the headset:
-
Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and
green LED will lit ones.
-
Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover
from the headset so that the registration key hole is free also.
-
Press the headset registration key. The red LED will flash rapidly.
-
If after a few seconds the green LED flashes slowly, the registration is successful.
-
If the red LED flashes slowly, the registration is failed. Repeat above procedure.
7.3 REMOVING A HANDSET
You can remove a handset from a base to allow another handset to be registered:
•
Press and hold the mute
and redial key
for 3 sec.
•
Enter the pin code (0000). If the pin is wrong, the handset will go back to standby.
•
Enter the handset number (1-5) you want to remove
•
The unit will go back to standby is the removal is successfully. If not, it will ask again to enter the handset number
Remark: You can only remove existing handsets and others then the one you are using
PIN
PIN 1234 H5-
H L _ B 2 8 0 0 . b o o k Page 10 Friday, August 29, 2003 1:16 PM