Tunturi E25 - Manual (Page 4)

4
O
W
N
E
R
’S
M
A
N
U
A
L
•
E
2
5
Attach the rear support from below with four hexagonal
socket head screws and washers. Attach the front
support to the frame with four screws and washers.
Restore the equipment to its upward position so that it
rests on the support feet.
pEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to
the right pedal crank turning clockwise and the left
pedal to the left pedal crank turning counterclockwise.
Fasten the pedal bands first into the retainerat the
device. Thread the band through the pedal loop and
push the band opening into the projection in the pedal.
Fasten the pedal bands to the pedal outside. Push the
band through the locking buckle and the band locks
automatically. The length of the band can be adjusted
with the locking buckle.
HANDLEBAR
Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar.
Ensure that the joint is securely locked by gently pulling
the wire. Thread the wire carefully inside the frame tube
and push the handlebar support tube into place inside
the frame tube so that the fastening screws are on the
front of the tube.
NOTE! Use the enclosed Allen key to tighten both
fastening screws through the holes in the tube.
Tighten the fastening screws by turning them counter-
clockwise.
CONSOLE
1. Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached.
2. Place the console in position at the end of the
handlebar support tube and attach the console using
two mounting screws.