beautypg.com

Maintenance, Step 2 | removing the headset after use, Using the system step 1 | using the headset – TV Ears Headphones User Manual

Page 6

background image

Maintenance

Replacing Ear Tips:

Your headset comes with foam TV Ears Tips attached. We also offer Silicone Ear Tips. The foam ear tips must be used

with black snap tip adapters; the silicone ear tips do not use snap tip adapters. Ear tips can be purchased from
TV Ears customer service.

The TV Ears headset receives an invisible infrared signal from the stack that is connected to the television.

Be certain that the infrared diodes located on the front of the stack are in direct sight with the front of

the headset to receive the signal. The infrared signal from the stack to the headset should be clear of any

obstruction (plants, books, furniture, etc.). The infrared signal cannot pass through walls or solid objects. The

headset can only pick up the infrared signal in the same room as the stack.

Step 2

|

Removing the Headset after use

Always use two hands to place and remove your headset from your ears. Using one hand may loosen or tug on the

bow arms and damage your headset.

1. Remove the headset from the charging cradle of the transmitter.

2. The BALANCE control is located on the back of the headset. The balance comes set

equal to both ears. To change the balance of volume to the right and left ears, insert

the balance control tool into the opening and turn the tool towards the ear you want

to increase the volume to.

3. The writing on the front of the headset should face away from your body. The

infrared signal is received on the front of the headset.

4. Using both hands, gently separate the bow arms and place earpieces into each ear

(similar to placing a stethoscope).

5. The VOLUME control will be located on the RIGHT side. Rotate the dial to turn ON

the headset and set the volume to your comfort level.

6. The TONE control (bass and treble) will be located on the LEFT side. Rotate the

dial to adjust the tone to your preference.

Using the System

Step 1

|

Using the Headset

2

8

1

3

6

1. Turn the headset OFF by rotating the VOLUME dial , reducing the volume until you feel or

hear a click.

2. Using both hands, gently separate the bow arms from your ears.

3. Remove the headset by lowering it under your chin.

4. Place the headset into the charging cradle of the transmitter.

1

Replacing the foam TV Ears Tips with new foam TV Ears Tips:

Note: Depending on usage, TV Ears Tips will become dirty and frayed. Replace TV Ears

Tips if they are soiled or show signs of wear. Do not re-attach or reuse ear tips after they

have become detached. For safety purposes, we recommend replacing TV Ears Tips every

30-60 days.

1. Use the top portion of the TV Ears Tips package to remove the ear tip from the

headset. Place the ear tip into the triangular cutout of the package.

2. Slide the ear tip to a corner and gently pull the ear tip off. The black snap tip

adapter should remain on the headset.

3. If a white o-ring remains on the tip of the snap tip adapter, remove it before

attempting to install a new ear tip.

4. Open the package of ear tips and place it on a level surface.

5. Place the pointed end of the snap tip adapter into the center hole of the new ear

tip and push down firmly until you feel the new ear tip snap.

6. Gently pull the headset away from the tray. Repeat with other ear tip. The ear tips

should now be installed.

Page 6