Toshiba HD-XA2KN - Manual (Page 22)

22
2
Chapter
2
Connections
Connecting to a TV (Continued)
Via component video input
Finally connect the supplied
power cord to a wall outlet.
Component video cables
(not supplied)
To COMPONENT OUTPUT
To use the analog sound output, connect these jacks
to audio input jacks on your TV using the audio cable,
and set “Speaker Setting” ( page 56) to “2ch”.
To use the digital output,
connect either of these
jacks to an audio input
on a device capable of
processing a Dolby
Digital, DTS bitstream
or PCM audio. ( page 25)
After completing the connection, proceed to page 23 to make the setting.
Via S-VIDEO or VIDEO (yellow) input
After completing the connection, proceed to page 23 to make the setting.
Connect either.
Finally connect the supplied
power cord to a wall outlet.
Audio/video cable (supplied)
S-VIDEO cable (not supplied)
To use the analog sound
output, connect these jacks
to audio input jacks on your
TV using the audio cable,
and set “Speaker Setting”
( page 56) to “2ch”.
To S-VIDEO To VIDEO
To use the digital output, connect
either of these jacks to an audio
input on a device capable of
processing a Dolby Digital, DTS
bitstream or PCM audio. ( page 25)
*
*
480i output only regardless of the resolution
settings or the connections of other output jack.
This player supports simultaneous output of video on its HDMI and component video ports. However, some discs may
restrict output of video on the component video ports when viewing high defi nition content or up-converted DVD content.
The resolution on the HDMI output will be the same as the resolution output on the component video output. Thus,
because the HDMI output can change automatically to match the maximum available resolution of your display, if you
connect both the HDMI output and component output, the resolution on the component output will change if the HDMI
output Auto-adjusts.
HD-XA2KN_02_E.indd 22 HD-XA2KN_02_E.indd 22 06.12.5 0:23:45 PM 06.12.5 0:23:45 PM