Targus PAKP003U - Manual (Page 7)

Power Management
To power the keypad and mouse on and off, slide the on/off
switch to the desired position.
When power is on, the mous e goes into “power saving
mode” after 4 minutes of inactivity. To activate the mouse,
move the mouse or press any button.
To save battery power, turn off the keypad and mouse while
traveling or when you’re not using them.
CAUTION: Removing the batteries will require you to
reset the ID code.
Operating Hints
For optimal performance and RF reception:
• Place the receiver at least 20 cm away from all electrical
devices, such as your monitor, speakers or external
storage devices.
• If necessary, use the supplied extension cable to keep the
receiver away from the computer. Plug the receiver into
the extension cable, and the extension cable to the
computer.
• Avoid using the optical mouse on a metal surface. Metals,
such as iron, aluminum or copper, shield the radio
frequency transmission and may slow down the mouse’s
response time or cause the mouse to fail temporarily.
• The mouse will enter a suspend mode at the same time
your computer does. To activate the mouse, press any of
the buttons.
• If your computer has a metal case that contains aluminum
or magnesium, use the optical mouse to the side. The
display panel may interfere with the radio frequency signal
if you use the mouse directly in front of the computer.
Targus wireless keypad and opitcal mouse combo
7