Troy-Bilt STORM Series - Manual (Page 11)

11
To Engage Drive
1. With the throttle control in the Fast (rabbit) position,
move shift lever into one of the six forward (F)
positions or two reverse (R) positions. Select a speed
appropriate for the snow conditions and a pace you’re
comfortable with.
2. Squeeze the auger control against the handle and the
augers will turn. Release it and the augers will stop.
3. Squeeze the drive control against the handle the snow
thrower will move. Release it and drive motion will
stop.
To Engage Augers
1. To engage the augers and start throwing snow,
squeeze the auger control against the left handle.
Release to stop the augers.
Auger Control Test
Perform the following test before operating your snow
thrower for the first time and at the start of each winter.
Check the adjustment of the auger control as follows:
1. When the auger control is released and in the
disengaged “up” position, the cable should have very
little slack. It should NOT be tight.
2. In a well-ventilated area, start the snow thrower engine
as instructed on the previous page. Make sure the
throttle is set in the FAST position.
3. While standing in the operator’s position (behind the
snow thrower), engage the auger.
4. Allow the auger to remain engaged for approximately
ten (10) seconds before releasing the auger control.
Repeat this several times.
5. With the throttle control in the FAST (rabbit) position
and the auger control in the disengaged “up” position,
walk to the front of the machine.
6. Confirm that the auger has completely stopped
rotating and shows NO signs of motion. If the auger
shows ANY signs of rotating, immediately return to the
operator’s position and shut off the engine. Wait for
ALL moving parts to stop before re-adjusting the auger
control.
7. To readjust the control cable, loosen the upper hex
nut on the auger cable bracket.
8. Position the bracket upward to provide more slack (or
downward to increase cable tension). See Figure 4-2.
9. Retighten the upper hex nut.
10. Repeat Auger Control Test to verify proper adjustment
has been achieved.
When selecting a Drive
Speed, use the slower
speeds until you are
comfortable and familiar
with the operation of the
snow thrower.
NEVER reposition the
shift lever (change speeds
or direction of travel)
without first releasing the
drive control and bringing
the snow thrower to a
complete stop. Doing so
will result in premature
wear to the snow thrower’s
drive system.
WARNING
Never use your hands to
clean snow and ice from
the chute assembly or
auger housing.
The muffler, engine and
surrounding areas be-
come hot and can cause
a burn. Do not touch.
4
Operating
Your Snow
Thrower
Figure 4-2