True Manufacturing Company TGU-2 - Manual (Page 7)

............ www.truemfg.com ............
True Food International Equipment, Inc.
5 5
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION OF LEGS AND CASTORS
Securing Castors
To obtain maximum strength and stability of the
unit, it is important that you make sure each castor
is secure. The bearing race on the castor of the top
edge of the leg must make firm contact with the rail.
Unit Leveling
Four leveling shims have been provided for leveling castored
units positioned on uneven floors. Shims must be positioned
between rail end and bearing race. TRUE recommends a four
shim limit to any single castor.
A. Turn the bearing race counter-clockwise until
the cabinet is level. Level front to back and side
to side. (diagonally)
B. Install the desired number of shims, making
sure the slot of the shim is in contact with the
threaded stem of the castor.
C. If more than one shim is used, turn the slot at a
90° angle so they are not in line.
D. Turn the bearing race clockwise to tighten and
secure the castor by tightening the anchoring
bolt with a 3/4 inch open-end wrench, socket,
or the tool provided.
CAUTION
To avoid damage to lower rail assembly, slowly raise unit to
upright position after installing castors.
Thread four screws into castor in the
underside of cabinet frame rail. Anchor the four screws firmly to the
base of the unit.
1 2