beautypg.com

Introduction, Installation – Tricity Bendix SB200 User Manual

Page 7

background image

7

WARNING: THIS APPLIANCE MUST BE EARTHED

RATING PLATE

This is situated on the front frame of the appliance
and can be seen upon opening the top cavity door.
Alternatively the rating plate may also be found on
the back or top of some models (where applicable).

The appliance must be protected by a suitably
rated fuse or circuit breaker.

The rating of the

appliance is given on the rating plate.

Do not remove the rating plate from the
appliance as this may invalidate the guarantee.

INSTALLATION

If your appliance has been damaged in transit,
contact

your

supplier

immediately.

DO

NOT

attempt to install it.

Your appliance left the factory fully packaged to
protect it from damage.

If it is delivered without

packaging

and

damage

has

occurred,

the

manufacturer cannot accept responsibility. Contact
you supplier for advice.

Once the packaging has been removed the
appliance should only be moved by hand.

DO

NOT use a sack barrow or any other aid to lift the
appliance as damage may occur.

Connection to the electricity supply must be carried
out by a qualified electrician/competent person.

The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles.

The

cable must have conductors of sufficiently high
cross-sectional area to prevent overheating and
deterioration.

Six

square

millimetres

(6.00mm

2

)

is

the

recommended cross-section area.

This is a type X appliance, which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may not be fitted any closer into a
corner than shown in the diagram below.

Side walls which are above hob level should be
protected

by

heat

resistant

non-combustible

material and MUST NOT be nearer than 40mm to
the hob side.

A nominal air gap of 10mm at the sides of the
appliance is required to enable the appliance to be
moved into position.

Overhanging surfaces or a cooker hood should be
a minimum of 685mm above the hob.

To move the appliance, open the main oven door,
and lift the appliance by holding inside the top of
the oven compartment.

INTRODUCTION