Troy-Bilt 1030 - Manual (Page 26)

26
OPERATORS VIEW
777S32066
FRONT TOP OF AUGER HOUSING
CUT FOOT PICTORIAL FACING
AWAY FROM OPERATOR
KEEP AWAY FROM ROTATING IMPELLER AND AUGER. CONTACT WITH IMPELLER OR AUGER CAN AMPUTATE HANDS AND FEET. USE CLEAN-OUT TOOL TO UNCLOG DISCHARGE CHUTE. DISENGAGE CLUTCH LEVERS, STOP ENGINE, AND REMAIN BEHIND HANDLES UNTIL ALL MOVING PARTS HAVE STOPPED BEFORE UNCLOGGING OR SERVICING MACHINE. TO AVOID THROWN OBJECTS INJURIES, NEVER DIRECT DISCHARGE AT BYSTANDERS. USE EXTRA CAUTION WHEN OPERATING ON GRAVEL SURFACES.
READ OPERATOR'S MANUAL.
1.
2.
3.
4.
5.
DANGER
CLEAN-OUT TOOL DANGER
AVOID INJURY FROM
ROTATING AUGER -
KEEP HANDS, FEET
AND CLOTHING AWAY.
REF. 777S32236
MOLD-IN GRAPHIC
DANGER
NEVER PUT HAND IN CHUTE. CONTACT WITH
ROTATING PARTS CAN AMPUTATE FINGERS
AND HANDS.
SHUT OFF ENGINE AND WAIT UNTIL ALL
MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING.
USE CLEAN-OUT TOOL OR WOODEN STICK TO
UNCLOG DISCHARGE CHUTE.
STOP
I22376 AC
CHOKE
THROTTLE
OFF
IGNITION KEY
REMOVE TO STOP
FULLY INSERT
TO RUN
FULL
(ON)
STOP
777I22376
PLACE ABOVE IGNITI ON
CUT-OUT
777D08455
777D08376
777I22343
777I22338
777I22375
TOP EDGE OF SHROUD
FACING OPERATOR
ENGINE CONTROLS
CHUTE DIRECTIONAL CONTROL
1.) INSERT IGNITION KEY AND SNAP IN PLACE.
2.) SET CHOKE AND THROTTLE TO FULL (ON) POSITION. PUSH PRIMER BUTTON 3x.
3.) ROPE START: PULL SLOWLY UNTIL HARDER TO PULL,
THEN PULL RAPIDLY TO START. REPEAT
PRIMING IF NEEDED.
ELECTRIC START: DO NOT USE IN RAIN. CONNECT POWER
CORD AND PUSH STARTER BUTTON.
REPEAT PRIMING IF NEEDED.
4.) MOVE CHOKE SLOWLY TO OFF POSITION.
5.) TO STOP ENGINE: MOVE THROTTLE TO STOP POSITION.
STARTING INSTRUCTIONS:
CHUTE TILT DOWN
CHUTE TILT UP
PUSH BUTTON
CHUTE ROTATE
LEFT
PUSH BUTTON
CHUTE ROTATE
RIGHT
RIGHT TURN CONTROL LEFT TURN
TRIGGER CONTROL RIGHT TURN
TRIGGER CONTROL DRIVE CONTROL
SHEAR PIN STORAGE
GO GO
DRIVE CONTROL AUGER CONTROL
?
777 I22378
DRIVE
AUGER
LOCK
777D03165
On each handle
grip
Safety & Decorative Labels