Technicolor - Thomson CDP-CX57 - Manual (Page 39)

– 49 –
7-12. IC PIN FUNCTION DESCRIPTION
• BD BOARD IC101 LA9241M (RF AMPLIFIER, FOCUS/TRACKING/SLED SERVO)
Pin No. Pin Name I/O Function
1 FIN2 I
Signal input (B+D) from the optical pick-up detector
Added with FIN1 to create RF signal, subtracted with FIN1 to create focus error signal
2 FIN1 I Signal input (A+C) from the optical pick-up detector
3 E I
Signal input (E) from the optical pick-up detector
Subtracted with F to create tracking error signal
4 F I Signal input (F) from the optical pick-up detector
5 TB I Tracking error signal input for the tracking balance adjustment
6 TE– I Tracking error signal (invert signal) input terminal
7 TE O Tracking error signal output terminal
8 TESI I
TES (Track Error Sense) comparator input terminal
Tracking error signal is band-passed and input
9 SCI I Shock detection input terminal
10 TH I Time constant setting terminal for the tracking gain adjustment
11 TA O TA amplifier output terminal
12 TD– I Creates a tracking phase compensation constant between TD (pin !£) and VR (pin %•) pins
13 TD O Setting terminal for the tracking phase compensation
14 JP I Setting terminal for the tracking jump signal (kick pulse) amplitude
15 TO O
Tracking coil (2-axis device) drive signal output to the LA6541 (IC103), and sled motor drive
signal output terminal
16 FD O Focus coil (2-axis device) drive signal output to the LA6541 (IC103)
17 FD– I Creates a focusing phase compensation constant between FD (pin !§) and FA (pin !•) pins
18 FA O Creates a focusing phase compensation constant between FD– (pin !¶) and FA– (pin !ª) pins
19 FA– I Creates a focusing phase compensation constant between FA (pin !•) and FE (pin @º) pins
20 FE O Focus error signal output terminal
21 FE– I Focus error signal (invert signal) input terminal
22 AGND — Ground terminal (analog system)
23 SP O Single end output of the CV+ (pin $º) and CV– (pin #ª) pins signal
24 SPI I Spindle amplifier input terminal (invert input)
25 SPG I Gain setting resistor is connected when the spindle 12 cm mode
26 SP– I Works together with the SPD (pin @¶) to connect to the spindle phase compensation constant
27 SPD O Spindle motor (M101) drive signal output to the LA6541 (IC103)
28 SLEQ I Sled phase compensation constant is connected
29 SLD O Sled motor (M102) drive signal output to the LA6541 (IC103)
30 SL– I Sled feeding signal input from the system controller (IC501)
31 SL+ I Sled feeding signal input from the system controller (IC501)
32 JP– I Tracking jump control signal input from the DSP (IC102)
33 JP+ I Tracking jump control signal input from the DSP (IC102)
34 TGL I Tracking gain control signal input from the DSP (IC102) Gain becomes low when TGL is “H”
35 TOFF I
Tracking off control signal input from the DSP (IC102)
Tracking becomes off when TOFF is “H”
36 TES O Tracking error signal output to the DSP (IC102)
37 HFL O
Tracking detection signal output to the DSP (IC102) HFL (High Frequency Level) is used to
determine whether the main beam is positioned on a pit or a mirror
38 SLOF I
Sled servo off control signal input from the DSP (IC102) Rough servo/phase control automatic
switching monitor input “H”: rough servo, “L”: phase servo
39 CV– I CLV error signal input from the DSP (IC102)