Telex PST-170 - Manual (Page 7)

Channel Selection and Input Adjustment
1. Turn the receiver on and plug a microphone into the mic jack.
A channel letter will show in the display.
2. Press the set button once and the Channel indicator will flash.
3. Press the button and the Channel will cycle up. Match the
channel to the receivers being used (SR-50, SR-100, SR-400
or check frequency chart to match other brands).
4. Press SET, the channel indicator will stop flashing and the in-
put level will be displayed and flash.
5. Speak into the microphone while watching the display. The
symbol will be displayed when the input is overmodulating
(too strong). Push the ARROW button to adjust the input level
until the
symbol shows just on the loudest speech.
6. When the input is adjusted, press SET and the display will
stop flashing and the channel will be displayed.
7. If the lights up during operations, it is indicating
overmodulation. Re-adjust the input level.
If the microphone and an auxiliary device is used at the
same time, it is preferable to set the auxiliary input device
with its own control.
Adjust the appropriate output level control until loud program
material passages sound natural in the receiver. This allows
sufficient "head room" to prevent peak distortion on loud in-
puts.
-6-