Programming channel memory, Tv/cable function, Ch program function – Toshiba 32A41 User Manual
Page 16: T/s t/s, Press s or t until tv/cable is displayed in purple, Preparation
16
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Programming the channel memory
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL
MUTE
CH
CH
VOL
VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
PAUSE
FF
SOURCE
STILL
PIP
SLOW
PIP CH
LOCATE
SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEO
FAV CH
A
EXIT
s/t
CHANNEL
s/t
T/S
MENU
CHANNEL t/s
t/s
T/S
MENU
3
Press T or S until the mode that
corresponds to your TV signal
system displays in purple.
TV: TV broadcast signals
(VHF channels 2 through 13 and
UHF channels 14 through 69)
CABLE: Cable TV signals
(Cable channels 1 through 125)
TV/CABLE function
1
Press MENU until the Setup menu is
displayed on-screen.
2
Press s or t until TV/CABLE is displayed
in purple.
CH PROGRAM function
Use the CH PROGRAM function to
automatically add all active channels to the
channel memory.
1
Press MENU until the Setup menu is
displayed on-screen.
2
Press s or t repeatedly until “CH
PROGRAM” is displayed in purple.
3
Press T or S to start channel programming.
The TV automatically cycles through all the
TV or CABLE channels (depending on the
mode selected), and stores the active
channels in the channel memory.
4
When channel programming is done, you
will see the message, “Ch Programming
Completed.”
5
Press CHANNEL s or t to scan through
the programmed channels.
TIMER:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
V-CHIP CONTROL
0 MIN
[TV]CABLE
[ADD]ERASE
FAVORITE CH
MOVE[t s] SELECT[T S]
TIMER:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
V-CHIP CONTROL
0 MIN
TV[CABLE]
[ADD]ERASE
FAVORITE CH
MOVE[t s] SELECT[T S]
TIMER:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
V-CHIP CONTROL
0 MIN
TV[CABLE]
[ADD]ERASE
FAVORITE CH
MOVE[t s] START[T S]
CH PROGRAMMING
COMPLETED
CH PROGRAM
CABLE 24
CABLE 4
The channel memory is the list of TV channels your TV stops on when you press CHANNEL
▲/▼.
First, use the TV/CABLE and CH PROGRAM functions (below) to program all active channels in your area into the channel
memory. Then use the ADD/ERASE function (page 17) to add/erase individual channels in the memory.
Channel
Number
MENU
TV / VIDEO
VOLUME
CHANNEL
POWER
Preparation