Technicolor - Thomson Proscan MULTIMEDIA MONITOR - Manual (Page 27)

Connections & Setup
25
LABEL THE CHANNELS
This last step in the setup routine lets you create your channel list and
label your channels.
1. From the Channel menu (shown below), select Lists and Labels.
CHANNEL
1 Signal Type
2 Auto Channel Search
3 List and Labels
4 Autotuning
0 Go Back
The Lists and Labels menu appears (shown below).
LIST AND LABELS
Channel Channel Channel
Number List Label
59 Yes FOX---
Use ^ or v, keypad, or CH ^/v
to set channel, MENU to exit.
2. Use the left and right arrows to point to the three different areas of
the control panel (called “fields”).
3. Use the up and down arrows to scroll through the numbers (or use
the digit keys on the remote) and letters and select Yes or No in the
Channel List field. You may wish to refer to the call letters listed in
your newspaper’s TV section for ideas on labelling the channels.
4. Repeat this process for each of your channels. Then press MENU
or OK to continue. The monitor can store in memory as many
as 45 labels.
WHAT NOW?
Now that you’ve finished the setup, you can sit back, relax, and enjoy
the monitor, or you can take a few minutes to program the remote to
control your VCR, DVD player, satellite receiver, or other components.
To find out how to program the remote, go to the next section.
Use the CH ^ (channel up) or CH v
(channel down) buttons to change
channels in the Channel Number field.
This works even if you’re not in the
Channel Number field. Or, enter the
channel number directly using the
number buttons on the universal remote.
To enter a number greater than 99, press
and hold “1” to enter the hundreds digit,
then press the two remaining numbers.
The list and labels feature can also be
accessed from the Channel menu.
Because this procedure can be time
consuming, feel free to skip this step and
come back to it later.