Technicolor - Thomson Proscan MULTIMEDIA MONITOR - Manual (Page 20)

18
Connections & Setup
TV ON OFF
AUX DVD
FETCH GO BACK
SKIP MUTE
INFO
MENU
OK
CLEAR
GUIDE
VCR1
VCR2 DIRECTV
CH +
CH -
V
O
L V
O
L
TV
button
SETTING UP THE MONITOR
Follow these steps when setting up the monitor for the first time.
STEP 1: PLUG IN THE MONITOR
Plug the end of the power cord into an appropriate wall outlet. Be sure
to insert the plug completely.
STEP 2: PLACE BATTERIES IN REMOTE
• Remove the battery compartment cover from the back of the
remote by pushing down on and sliding off the cover.
• Insert fresh batteries. Make sure that the polarities (+ and -) are
aligned correctly.
• Replace the cover.
STEP 3: TURN ON THE MONITOR
Press TV on the remote, or press POWER on the monitor’s front panel.
Pressing the TV button not only turns on the monitor, but puts the
remote into TV mode, so that the buttons on the remote will control
monitor functions.
STEP 4: SET UP THE MONITOR
The information that follows gives you step by step instructions for the
first time set up of your monitor. Take time now to read the next
section, “Setting Up Your Monitor,” and complete the set up routine.
FIRST-TIME SETUP
The first-time setup of your monitor includes: setting the time, auto
channel search, setting up the auto tuning feature, and labeling the
channels and inputs. Refer to this section if you ever need to reset any
of these initial settings.