Toshiba STRATA CTX DKT3000 - Manual (Page 44)

Advanced Operation
Call Forward
30
Strata CTX DKT3000/2000-Series Telephone 05/02
➤
To use the Call Forward button sequence
➤
Follow the instructions in the following table, shown under “Button Sequence.”
Some features require additional input, such as:
• Destination – If the destination is an outside number, press ÆÃ after entering the
destination. The CTX accepts destination numbers of up to 32 digits.
• Timer – This is a two digit entry representing how long (eight to 160 seconds)
your telephone should ring before forwarding the call. If you enter one digit,
you must press
ÆÃ after entering the single digit.
• Pass Code – A four-digit code established by system programming to prevent
unauthorized changes. The code applies to the station to be forwarded; not to
the station entering the code.
Note In the following table, (Tone) means that a confirmation tone will play at that
point in the sequence.
Table 2 Call Forward Procedure
Feature Button Sequence
Call Forward Any Call - Internal and Incoming Line Calls:
Forwards any call, whether an internal call or incoming line call.
All Calls Extension (Ext.) button + Æ% (Tone) + Destination No. (Tone)
Busy Ext. button + Æ%! (Tone) + Dest. No. (Tone)
No Answer Ext. button + Æ%" (Tone) + Dest. No. (Tone) + Timer + Æ
Busy No Answer Ext. button + Æ%# + Dest. No. + Timer + Æ
Cancel Ext. button + Æ%$ (Tone)
Call Forward - Incoming Line Calls:
Forward incoming line calls only.
All Calls Ext. button + Æ% " (Tone) + Dest. No. (Tone)
Busy Ext. button + Æ%!" (Tone) + Dest. No. (Tone)
No Answer Ext. button + Æ%"" + Dest. No. (Tone) + Timer (Tone) + Æ
Busy No Answer Ext. button + Æ%#" + Dest. No. (Tone) + Timer (Tone) + Æ
Cancel Ext. button + Æ%$" (Tone)