Tascam US-144MKII - Manual (Page 15)

TASCAM US-144MKII
15
Installing the driver for Mac OS X
Confirm that the US-144MKII is not 1
connected to the computer.
Double-click the "
2 US-122MKII_US-
144MKII_1.14.dmg" on the included
CD-ROM. The "TASCAM_US-
122MKII_US-144MKII_1.14.mpkg" is
created on the desktop.
Dboule-click the "
3 TASCAM_US-
122MKII_US-144MKII_1.14mpkg" on
the desktop to launch the installer.
Follow the instructions on the screen to
4
conduct the installation.
Restart the computer and then connect
5
the unit.
Uninstalling the driver
Windows
There are two ways to uninstall the driver as
shown below.
Using the Installation CD-ROM: •
Follow steps 1 to 4 under “Installing 1
the driver for Windows” (See page 13.)
At step 5 of the procedure, click
2
“Remove the driver”.
Follow the instructions on the screen 3
for the remaining procedure.
Using Windows “Add or Remove •
Programs”
Open the “ 1 Control Panel” from the
“Start” menu.
Double click on “
2 Add or Remove
programs”.
Select “
3 US-122 MKII / US-144 MKII”
from the list and click “Change or
Remove Programs”.
Follow the instructions on the screen
4
for the remaining procedure.
Mac OS X
Insert the CD-ROM into the PC and 1
double click “TASCAM US1xx remover”
icon.
Follow the instructions on the screen 2
for the remaining procedure.
Frequently asked installation
questions and answers (FAQ)
Windows driver installation
Q: When I connect the unit to a computer,
the Windows “Hardware Wizard”
appears and I cannot install the
driver. Am I making a mistake in the
installation procedures?
A: Close the Windows “Hardware Wizard”
and disconnect the unit. You must install
the driver before connecting this unit.
Insert the CD-ROM included with the
product. The menu for installing the
driver appears automatically.
3 – Installation