Tannoy iw6 DS - Manual (Page 9)

Tannoy United Kingdom
Tannoy North America
Tannoy Deutschland
Tannoy France T: 00 44 (0) 1236 420199
T: 00 1 (519) 745 1158
T: 00 49 (180) 1111 881
T: 00 33 (0)1 7036 7473 E: [email protected]
E: [email protected]
E: [email protected]
E: [email protected]
iw6 DS
Tannoy adopts a policy of continuous improvement and product specification is subject to change iW6DC data file issue:1.06 // 15.01.08
The in wall speaker shall consist of one 165mm (6.50") bass unit and one 25mm (1.00") high frequency driver mounted in an injection moulded front baffle
manufactured from UV/weather resistant UL94V-0 ABS material. The two-way system shall incorporate an optimised low loss crossover network. The wiring
terminals shall be gold plated spring loaded connectors. Performance of the in wall speaker shall meet or exceed the following criteria: The system shall
have a coverage angle of 130 degrees (1kHz to 6kHz). Frequency response measured on axis shall be 44Hz - 54kHz (-10dB from rated sensitivity,
measured in an IEC baffle in an anechoic chamber) with no equalization. Sensitivity shall be 89dB (1W @ 1m). Long term power handling capacity as
defined in EIA-426B test shall be 75W, recommended amplifier power 150W @ 8 Ohms. The nominal system impedance shall be 8 Ohms.
In 70V or 100V distributed audio systems the iw6 DS can be used with the optional the THP60 high performance, low insertion loss transformer with
60, 30,15 and 7.5W taps* available.
A weather resistant perforated steel grille covers the transducer. Both the grille and baffle shall be paintable. The system shall not exceed the following
dimensions: 320 x 209 x 98mm or 12.60 x 8.25 x 3.86” (H x W x D).
Hole cutout size shall be 271.50 x 168.50mm or 10.71 x 6.63".
The in wall speaker system shall be the.....iw6 DS.
*70.7 Volt only
Architectural specifications