Tripp Lite B013-000 - Manual (Page 8)

Installation
Setting up the Console Extender System is simply a matter of
plugging in the cables:
1. Make sure that all the equipment to be connected up is powered Off.
2. Plug the cables from the local console devices (mouse, keyboard,
monitor), into their ports on the Console side of the Local Unit
(B013-000 Local).
3. Plug the appropriate connectors on the KVM extension cable
supplied with this unit into the CPU side of the B013-000 Local.
Each connector is marked with an appropriate icon to indicate
which it is.
Note: The female monitor connector is the one that plugs into the
B013-000 Local.
4. Plug the connectors on the other end of the cable into the
appropriate ports on the PC system (or Console section of the
KVM switch - if you are using one). Each connector is marked
with an appropriate icon to indicate which it is.
5. Plug either end of the Category 5 twisted pair cable into the
B013-000 Local’s Remote I/O port.
6. Plug one of the power adapters (supplied with this package) into
an AC source; plug the adapter’s power cable into the B013-000
Local’s Power Jack
7. Plug the other end of the Category 5 twisted pair cable into the I/O
port of the Remote Unit (B013-000 Remote).
8. Plug the cables from the remote console devices (mouse,
keyboard, monitor), into their ports on the Console side of the
B013-000 Remote.
9. Plug the second power adapter (supplied with this package) into
an AC source; plug the adapter’s power cable into the B013-000
Remote’s Power Jack.
2001-02-05
- 8 -