Tiger Products Co., Ltd JD 5520 - Manual (Page 59)

Triple Flail Maintenance Section 4-3
MAINTENANCE
REGULAR MAINTENANCE
The intervals at which regular servicing should be done are based on hours of
operation. Use the tractors hour meter to determine when regular servicing is
required.
This symbol indicates a point that needs to be greased at an interval
noted in the section below. Refer to the Detailed Maintenance section
for further instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
DAILY OR EVERY 8 HOURS
ITEM SERVICE COMMENTS
Drive Shaft Yoke, U-Joint Grease Grease as instructed in
& Stub Shaft detailed maint. section
Pump Drive Shaft Check and Lube Insure drive shaft end play
Crankshaft Adapter Check rubber grommets Replace grommets if
damaged or missing
Pivot Points Lubricate Inject grease until it appears
at ends
Hydraulic Fittings Check for leaks Tighten when needed.
Do Not use hands to check
for leaks, see maintenance
Precautions
Knives Check Inspect for missing or
damaged knives, change
or sharpen as needed
Cutter shaft mounting bolts Check 1/2” x 2” torque to 84 ft. lbs.
(cutter shaft to deck
)
Knife mounting bolts Check Retorque to knife
(knife to cutter shaft) replacement specifications
Belts Check / Adjust Check if broken, tighten
as required
Main Frame and Check Retorque bolts to troque
Deck specifications in this section
Hydraulic Fluid Level Check Add if required per
fluid recommendations
Rear Flail Drive (if applicable) Lubricate Grease as instructed in
Bearing Flange and detailed maint. section
Shaft Coupler
Cutter Shaft and
Lubricate Grease as instructed
Ground Roller in detailed maint. section