Targus 410-0008-001A - Manual (Page 6)

6
Targus Wireless Laser Rechargeable Notebook Mouse
3 Insert the supplied batteries, making sure that the
positive (+) and negative (-) ends of each battery
match the polarity indicators inside the battery
housing.
WARNING: W HEN REPLACING THE BATTERIES , USE ONLY HEAVY - DUTY N I MH
RECHARGEABLE BATTERIES . N EVER USE ALKALINE BATTERIES .
A VOID MIXING NEW AND USED BATTERIES IN A DEVICE .
4 Slide the battery cover back into position until it
“clicks” firmly into place.
5 Turn on the mouse by sliding the on/off switch on the
bottom of the mouse to the “on” position.
N OTE : W HILE THE MOUSE IS FUNCTIONING , NO LASER LIGHT IS VISIBLE TO THE
NAKED EYE . B E CAREFUL NOT TO LOOK DIRECTLY INTO THE EMITTER HOLE
WHILE THE MOUSE IS ACTIVE .
Charging the Batteries
For best results, you should charge the mouse at least 4
hours before using it. You can do this via the supplied
USB charge cable. To do this:
1 Connect the cable’s USB connector into an available
USB port on your computer.
2 Connect the other end to the mouse.
NOTE: T O CONTINUOUSLY CHARGE THE MOUSE VIA THE USB CHARGE CABLE ,
YOUR COMPUTER MUST BE ON AND AWAKE . F OR BEST RESULTS , TURN OFF
YOUR COMPUTER ’ S POWER MANAGEMENT FEATURE WHILE CHARGING THE
MOUSE .