Teac X-03 - Manual (Page 15)

15
Repeat mode
< Halting playback stops the repeat mode.
< The following buttons cancel repeat mode:
STOP, OPEN/CLOSE, POWER.
Track repeat
When this is selected, the currently-selected track repeats. If
another track is selected during repeat playback, the newly-
selected track repeats.
Disc repeat
The whole contents of the disc are repeated.
Programmed repeat
If programmed playback has been set up, the whole program
is repeated.
Pushing the REPEAT button cycles between REPEAT PGM
(program repeat) and REPEAT OFF (programmed playback
takes place).
Use the REPEAT button to select the repeat mode for
playback. Repeated presses of the REPEAT button cycle
between the following options:
REPEAT TRK
(track repeat)
REPEAT DSC
(whole disc repeat)
REPEAT OFF
(no repeat)
Analog output (2CH/MULTI)
When playback is stopped, use the 2CH/MULTI button to select
either 2CH (stereo) or MULTI (multi-channel surround) audio
output.
2CH
The unit outputs 2-channel stereo sound from the the i.LINK
(AUDIO) and the AUDIO OUT terminals.
If multi-channel program material is played, the multi-channel
material will be downmixed to two channels and the
DOWNMIX indicator will light on the display.
MULTI
The unit outputs the multi-channel surround sound.
Select this when the i.LINK (AUDIO) terminal is connected to a
surround sound amplifier.
5.1 indicator will light on the display.
< Note that if “MULTI” is selected, only the front L/R sound of
the multi-channel material will be output from the analog
AUDIO OUT terminals.
< This setting is also reflected on the setup menu.
< This setting has no effect on the DIGITAL OUT terminals.