Telenetics OMEGA CDMA - Manual (Page 23)

AT Commands
Table A-4. Cellular CDMA Commands
AT Command Parameter Description
*RPASS= [string] Set the remote user login password.
*RPASS? Display the remote user login password.
*RSSI Display the Received Signal Strength.
*RUSER= [string] Set the remote login username.
*RUSER? Display the remote login username.
*SIP= [xxx.xxx.xxx.xxx] Set the remote server IP address.
*SIP? Display the remote server IP address.
*T= [secs] Set the maximum connection time.
*T? Display the maximum connection time.
*UDP= 1 Enable UDP.
0 Disable UDP.
*UDP? Display UDP activation.
*VM= [config] Set the default modem AT configuration.
*VM? Display the default modem AT configuration.
*VT= [config] Set the default transceiver configuration.
*VT? Display the default transceiver configuration.
*W Save the active configuration.
*WTCP= 1 Enable TCP waiting for ACK.
0 Disable TCP waiting for ACK.
*WTCP? Display the TCP waiting activation.
+CAD? Query analog or digital service.
0 Disable cellular result codes (default). +CRC=<value>
1 Enable cellular result codes.
0 Asynchronous data (default).
1 Packet data service, relay layer transceiver interface.
2 Packet data service, network layer transceiver interface
PPP.
3 Packet data service, network layer transceiver interface
SLIP.
+CRM=<value>
4 STU-III service
0 Ignored +CQD=<value>
1-255 Release call after 5x<value> seconds elapse.
+CMIP? Mobile station IP address
+CBIP? Base station IP address
+CSS? Identifies if mobile station is registered with A- or B-band,
or not registered.
+CSQ? Query Received Signal Quality
!RSSI? Received line signal strength
!STATUS Status of the OMEGA CDMA modem
Page 23