Toshiba 1202kit - Manual (Page 5)

Congratulations on your purchase of a Toshiba DVD-RAM drive and Kit. The
following information will help you in the simple installation of your new DVD-
RAM drive.
CHECKING YOUR KIT PACKAGING
Please unpack your DVD-RAM kit, and assure that you have the following items:
! Toshiba SD-W2002 DVD-RAM Drive
! Blank Media - Single Sided/Type 1 DVD-RAM
! CyberLink PowerDVD
™ Software
! VOB InstantWrite Software CD
! DVD-RAM Installation Instructions (this manual)
! Quick Start Guide
! Mounting screws
(4)
! IDE BUS cable
! DVD/CD sound cable
Additional items you may need that are not included in the kit are:
! Phillips Screwdriver
! Mounting hardware (i.e. some computer systems use mounting rails).
SYSTEM REQUIREMENTS
The DVD-RAM kit requires the following:
✔ At least 55MB of free hard disk space
✔ At least 32MB of RAM
✔ *Pentium II processor at 266MHz or higher or....
*Celeron 300A processor or higher or....
*K6-2 processor at 300MHz or higher
✔ Display card supporting DirectDraw
✔ 16-bit or better sound card
✔ Microsoft
™ Windows 95 or higher
✔ Amplified stereo speakers
* These requirements are only required if you are using the CyberLink PowerDVD ™
software. The SD-W2002 DVD-RAM will work as a CD-ROM and DVD-RAM
when using a lower speed Pentium system.
1