Transition Networks P332MF - Manual (Page 25)

Establishing a Telnet Connection
Issue 1 September 2005 25
4. At the prompt, type:
set interface inband
Replace , and with the VLAN,
IP address, and net mask of the stack.
5. Press Enter to save the IP address and net mask.
6. At the prompt, type reset. Type y and press Enter to reset the stack. After the Reset, log
in again as described above.
- At the prompt, type set ip route and replace and
with the destination and gateway IP addresses.
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the P330 for configuration of
Stack or Router parameters. You can Telnet the Stack Master IP address:
1. Connect your station to the network.
2. Verify that you can communicate with the Avaya P330 by pinging the IP of the Avaya
P330. If there is no response using ping, check the IP address and default gateway of both
the Avaya P330 and the station.
Tip:
Tip:
The Avaya P330 default IP address is 149.49.32.134 and the default subnet
mask is 255.255.255.0.
3. From the Microsoft Windows taskbar of your PC click Start and then Run (or from the
DOS prompt of your PC), then start the Telnet session by typing: telnet
For example: telnet 149.49.32.134
4. If the IP Address in the Telnet command is the IP address of the stack, then connection is
established with the Switch CLI entity of the Master module.
● The “Welcome to P330” screen appears
5. Enter the default name root at the Login name prompt.
6. Enter the User Level password root in lower case letters (do not use uppercase letters) at
the Password prompt.
● The User level prompt will appear when you have established communications with
the Avaya P330.
You can now configure the Avaya P330 stack and change its IP address.