ARIETE Eco Power 2788 - Manual (Page 11)

EN
- 9 -
VACUMM CLEANER ASSEMBLY
IMPORTANT: Before fitting or removing attachments, always make sure that the vacuum cleaner has
been unplugged from the power mains.
- Insert the suction device coupling (N) into the air inlet opening (H) and press until it clicks into
place. To remove it, it is necessary to press the two release buttons (R) at the same time and to
pull it out (Fig. 2).
- Insert the telescopic tube (M) into the handle (Fig. 3).
- Push the slider device (L) forwards and pull the bottom section of the tube out to the required
length (Fig. 4). To shorten the tube, push it back in the opposite direction.
- Fit the required attachment to the telescopic tube.
USING THE APPLIANCE
CAUTION: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord completely and plug the appliance
into the mains socket.
To switch on, press the foot switch (F) on the appliance. The cleaner is equipped with wheels to
move it easily during use.
IMPORTANT: The appliance might make a whistling sound that will stop after a few seconds.
WARNING: Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic tube
become blocked. Remove the cause of the blockage before switching the vacuum cleaner on
again.
After using the cleaner
Switch off the appliance using the foot switch (F).
Then unplug the appliance from the mains power and hold down the foot pedal (C) on the appliance
until the power cord is fully rewound.
WARNING: While rewinding the power cord, guide it in the right direction by hand to prevent any
risk of injury to yourself.
Put away the appliance, placing the floor brush (O) on the special hook in the back (Fig. 5).
Carrying the vacuum cleaner
Only carry the appliance using the special handle on the top part (G).
CLEANING AND MAINTENANCE
WARNING: Before carrying out any cleaning or maintenance operation, switch off the appliance and
unplug it from the mains power.
The dirt vacuumed up will enter the dust container (A). The air is cleaned by a permanent washable
filter that is located inside the dust container, by a motor protection filter and an air outlet filter located
under the appliance.