Testing a wireless telephone – TDK 3300 ICP User Manual
Page 29

SpectraLink Corporation
Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 ICP and 5220 IP Phone emulation
PN: 72-1084-02-B.doc
Page 29
8. Testing a Wireless Telephone
Verify proper registration and operation of each Wireless Telephone by performing the
following tests on each Wireless Telephone in an active wireless area.
1. Power on the Wireless Telephone by pressing
Power On
. You will see a series of
messages displayed as the Wireless Telephone acquires the system. The Wireless
Telephone should display the user extension or dashes if no extension is
programmed. Any error messages should clear.
2. Press the
Start Call
key. The extension number should be replaced by information
from the supported Mitel Networks VoIP solution and you should hear dial tone.
Place a call and listen to the audio quality. End the call by pressing the
End Call
key.
3. Place a call to the Wireless Telephone and verify ring, answer, clear transmit, and
clear receive audio.
4. Go off-hook and use the
FCN
key to verify the Features list.
5. Go off-hook and use the
LINE
key to verify the Line appearances / Line features
list.
6. Press the
End Call
key. Any line indicators should turn off and the extension
number display will return.