Topcom AGIA - Manual (Page 22)

39
Agia
38
Agia
Recording a telephone conversation
You can also record an ordinary 2-way telephone conversation with this
machine.
1. Press and hold the MEMO/FAST FORWARD button (7) for 2-3 seconds
to record a 2-way telephone conversation. A long BEEP will sound.
Note: Adjust VOLUME CONTROL (13) to the minimum sound level, so the
called party cannot hear the long beep sound.
2. Reduce the VOLUME (13) if necessary to eliminate audio feedback.
3. Begin your conversation as soon as the LED-indicator (5) lights.
4. Press the STOP button (6) to end recording. A BEEP will sound and your
machine will rewind the cassette tape.
Note: Be sure to stop recording when you have finished the telephone con-
versation, otherwise the line will remain (connected) even though the handset
is replaced.
5. To play back 2-way conversation recordings, press and release the
PLAY/REWIND button (8) .
6. Adjust VOLUME CONTROL (13) for comfortable listening level.
7. After the recording has played, your unit will sound 2 BEEPS and will automat-
ically rewind the microcassette tape to the beginning.
REMOTE CONTROL
IMPORTANT: Always call from a true touch tone telephone (DTMF) for remote
operation of your unit. The decoder is available as an option.
To operate your unit by remote control you first have to gain access to your unit
by using a Security Code. This unit is factory preset with code 689. However,
this security code can be changed to a maximum of 5 digits and a minimum of 1
digit.
To change the security code by remote control
1. Dial your telephone number.
2. Press the * button on hearing your OGM. The OGM stops and you hear 2
beeps,
3. Enter the security code “689”, When the code is correct you hear 2 beeps ,
When the code is wrong, you hear 3 beepsand the machine turns off. You
then have to start over,
4 Press and “1” and you hear 2 beeps.
5 . On hearing another BEEP, enter your new security code which has to consist
out of 3 digits.
6. Press . Your unit will emit 2 beeps to confirm the new security code.
* In case you have forgotten your new security code, switch off the supply and
switch it on again after 10 seconds. The machine will automatically revert to
security code 689.
* Do not use the same number for both security and CBT code (Call Break
Through).
To switch to auto-answer mode by remote control
1. Dial your telephone number.
2. After 12-14 rings, you will hear a beep.
3. Press the * button followed by the security code.
4. The OGM will play to confirm that the machine is in AUTO-ANSWER mode.
To switch off answer mode by remote control
1. After listening to all ICM’s and on hearing 2 BEEPS, press “5”.
2. 2 Beeps will sound to confirm ANSWER OFF mode.