TOA Electronics ALARM INPUT UNIT C-AL80(H) - Manual (Page 8)

8
3
REMOTE OFF
REMOTE ON
4
LEVEL
EDGE
5.3. Alarm/Remote Output Settings
It cannot be used.
Please fix to the "Remote OFF"
(Factory-preset position: "Remote OFF")
5.4. Alarm Interval Settings
Set the alarm time interval to "Edge" or "Level" with Model Selection
switch 4.
Selecting "Edge" causes the system to operate on alarm for a
specified period of time (Alarm Interval set by the Remote
Controller) when an alarm signal is received. If "Level" is selected,
the system continues to operate on alarm as long as an alarm signal
is input. In this event, the alarm cannot be reset with the Alarm
Reset key of the Remote Controller.
Set Mode switch 4 to the lower "Edge" position to select Edge, and
upper "Level" position to select Level. When a master/slave
connection is established, only the master unit's setting is valid.
(Factory-preset position: Edge)