Toshiba 26WL66A - Manual (Page 13)

13
Getting started
Programming channels into the
TV’s channel memory
• First, use the Auto tuning function to preset all the active
channels in your area automatically. Then, arrange the
preset channels with the Manual tuning function so that you
can tune into only desired channels.
• Use the Manual tuning operation if desired channels cannot
be preset with the Auto tuning or if you would like to preset
channels to specific position numbers one by one.
Programming channels automatically
1
Press
M, then press I or i to display the SET UP menu.
2
Press u or U to select Auto tuning.
3
Press
Q to display the Auto tuning menu.
4
Press
Q to start the automatic search.
The search will begin for all available stations.
The slide bar will move along the line as the search
progresses.
If you make a mistake, simply repeat steps 1-4 to start
again from the beginning.
5
When the automatic search is completed, the TV will
automatically return to the first program position.
6
Press > or < to view the programmed position.
Note:
When you preset the program channel which sound of
broadcast transmission system adopts "M" system, the sound
system may not be tuned correctly if the radio waves transmit
badly. At that time, preset the channel by Manual tuning.
The countries such as Myanmar, Brazil, Chile, Colombia apply
to this case. See page 28 for more details.
Manually setting channels in the channel
memory
1
From the SET UP menu, press u or U to select Manual
tuning.
2
Press
Q to display the Manual tuning menu.
Press u or U to select the program position you want to
arrange.
3
Press
Q to display the breakdown menu.
Press I or i to select an item, then press u or U to select
the item as shown below.
A. Program position selection
B. Sound system (- page 28)
C. Color system (- page 28)
A : Automatic (factory set), P : PAL, S : SECAM
N4 : NTSC 4.43 (MHz), N3 : NTSC 3.58 (MHz)
If the color of a certain channel is abnormal, the
automatic color system selection (A) may have
malfunctioned, or sound system selection is wrong. In
such a case, select another color and/or sound system
(- page 28).
D. Program position skip selection
Press u or U to turn the program position skip option
on “8” or off “(”.
The program position will then be skipped when you
select channels with > or <.
The “8” mark will appear beside a program position
number when you use the Number button on the
remote control.
E. Channel search operation
Press U to search up the band or u to search down the
band.
Press u or U repeatedly until your desired channel is
displayed.
When a station/satellite is found, it will be displayed.
NEVER PRESS ANY OTHER BUTTONS WHILE
THE SET IS TUNING.
F. Auto Fine Tuning
Press u or U to turn the Auto Fine Tuning option on
“9” or off “0”.
The Auto Fine Tuning function automatically corrects
slight fluctuations when receiving signals.
Manual Fine Tuning
While the Auto Fine Tuning turn off “0”, press u or U
so that the better picture and sound are obtained.
AV connection
Manual tuning OK
OK
Picture position OK
Auto tuning OK
Language
SET UP
MENU Back Watch TV EXIT
English
MENU Back Watch TV EXIT
Auto tuning
EXIT for no change.
Press OK key to start. !
Searching
Stop
Pos :2
Auto tuning
EXIT
5
4
3
2
1
MENU Back Watch TV EXIT
6
OK
Manual tuning
Prog. Label
Select Sort
A C E
B D F
G
MENU Back Watch TV EXIT
OK
Manual tuning
Store
1 B/G
Program
A
(continued)