Tripp Lite SUPER 10+TEL - Manual (Page 3)

SPECIFICATIONS
Super 10+TEL Super 10+TEL Deluxe Super 10+TEL DBS
Surge Energy Absorption (joules): 2300 2800 2100
Surge Current (NM/CM): 42.5/54.5 ka 49/54.5 ka 42.5/54.5 ka
Telephone Line Protection*: two line two line one line
Coaxial Protection**: - - two signal lines
* 2 female "RJ" jacks; 260V peak +/- 10% (clamping voltage);<1 picosecond (response time); 6Kv, 10 microseconds (peak transient
input voltage); 2 pair (wires 2, 3, 4, 5) protected
** 4 female "F" coaxial connectors; 24,000 amps (peak pulse power dissipation); 240 joules energy absorption; Less than .5 dB
insertion loss
ALL MODELS
Let-Through Voltage: <35 volts
UL 1449 (1998 rev.): 330 volts
Response Time (Normal Mode): Instantaneous (0 ns),
except Super 10+TEL DBS: <1 ns.
Protection Modes: Line to Neutral, Line to Ground, and Neutral to Ground
EMI/RFI Line Noise Filtering: >80 dB @ 1 MHz
AC Outlets: 10 NEMA 5-15R
AC Line Cord: 10 ft., 14 gauge, 3 conductor grounded
Dimensions (HxWxD, in.): 2 x 3½ x 10¾
Agency Approvals: UL 1449 TVSS, UL 1363, UL 479A, UL 1283, cUL
3
SUPER 10+TEL DBS TYPICAL CONNECTION DIAGRAM
(protecting satellite receiver, TV, VCR and stereo)
Canadian National
Standards
Certified by UL
Connect the coaxial cable from the antenna/CATV wall jack directly to the Super 10+TEL DBS
coaxial jack labelled "ANT/CATV IN". If you are also connecting a satellite dish, connect the
coaxial cable from the satellite dish to the Super 10+TEL DBS coaxial jack labelled "SAT IN".
If you are connecting a satellite receiver, connect two coaxial cables from the receiver to both of the
Super 10+TEL DBS coaxial jacks labelled "OUT", corresponding to the dish and wall jack inputs.
If you ARE NOT connecting a satellite dish (as illustrated below), connect a coaxial cable from the
device to be protected (VCR/TV) directly to the coaxial jack labelled "ANT/CATV OUT".
IN OUT IN OUT
SAT ANT/CATV
200007140 Super 10 Series OM 93-1848.p65 8/4/00, 3:27 PM 3