Toshiba 26HL86 - Manual (Page 11)

11
HL86 (E/F) Web 213:276
Chapter 2: Connecting your TV
About the connection illustrations
You can connect different types and brands of devices to your
TV in several different configurations. The connection
illustrations in this manual are representative of typical device
connections only. The input/output terminals on your devices
may differ from those illustrated herein. For details on
connecting and using your specific devices, refer to each
device’s owner’s manual.
Connecting an antenna or cable TV
This connection allows you to watch TV programs or basic
cable channels.
Connecting a VCR and antenna or
Cable TV (no Cable box)
You will need:
• coaxial cables
• standard A/V cables
– For better picture performance, if your VCR has S-video,
connect an S-video cable and standard (analog) audio
cables to the VIDEO-2 inputs on the side panel (instead of
the VIDEO-1 inputs). Do not connect both types of video
cable to VIDEO-2 at the same time or the picture
performance will be unacceptable.
– If you have a mono VCR, connect L/MONO on the TV to
your VCR’s audio out terminal using the white audio cable
only.
To view the antenna or Cable signal:
Select the antenna/cable channel input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the Video 1 video input source on
the TV.*
*To select the video input source, press + on the remote control
( - page 30). To program the TV remote control to operate other
devices, see “Using the remote control to operate your other devices”
on page 19.
From anntena or cable
TV lower back panel
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Law and may subject you to
civil and criminal liability.
IN from ANT
VIDEO AUDIO
OUT to TV
L R
R L
OUT
IN
CH 3
CH 4
Stereo VCR
From Cable TV or antenna
TV upper back panel
TV lower back panel
263237HL86_EN.book Page 11 Monday, April 24, 2006 12:48 PM