Toshiba STORAGE DEVICE DIVISION SD-R5002 - Manual (Page 17)

15
DRIVE CONNECTORS –SD-R5002
Figure 1.SD-R5002 DVD Rewriteable Drive Rear Panel - Connectors
Power
Connector Power is supplied to your DVD drive by the connection with your computer's +5V/+12V
power cable to the power socket at the back of drive. One side of the plug has
chamfered edges, so the power connector fits only one way.
CAUTION: Severe damage to the Drive circuits may occur if power cable is plugged in
upside-down with power ON.
Audio
Connectors Supplies Analog and Digital sound to your system.
ATAPI
Connector The SD-R5002 DVD drive is connected to your computer system through the ATAPI
connector.
Mode Select
Jumper The mode select jumpers are 6 straight angle pins located on the rear of the DVD
drive. By placing a jumper on the pins, you can select the following functions: CL
(CSEL), SL (Slave) or MA (Master). (see Setup for additional information).