beautypg.com

Telenetics MIU14.4 User Manual

Page 24

background image

MIU Installation, Operation & Diagnostics Edition: March 30, 1998 Page 22

&T7 INITIATE RDL WITH LOCAL SELF TEST (See Figure 5)

This is a system test, end to end.

The command is valid only if the modems are in the command state with
a connection established.

Configure the remote modem with an AT&T4 command so that it will
honor a remote digital loopback request.

Enter AT&T7 at the local modem and it will send a digital loopback
request to the remote modem. After the RDL acknowledgment signal is
received from the remote modem, DSR is turned off (if &S1 is in
effect), the on-line state is entered, an OK result code is sent to the DTE,
and the test timer is set to the value in S18. While the test is active, the
local modem sends a test message to the remote modem and counts the
errors in the received (looped back) signal. The modems stay in the
command state during the test. When the test is terminated (except by a
loss of carrier), the local modem sends the release signal to the remote
modem, as in &T6, and reports the three-digit error count to the DTE.

The information text is followed by an OK result code. The test is
terminated by loss of carrier, or an H0, &T0, or Z command, and by the
S18 timer running out.


RESULT CODES

DESCRIPTION

OK When

command

executed is started.

OK After

error

count

is sent to DTE (&T1,

&T3, &T6, &T7 or &T8).

ERROR

If not in on-line command state.

ERROR

If the RDL signal is not acknowledged.

This manual is related to the following products: