Transition Networks MIL-SW8T1GPA - Manual (Page 29)

27
RSTP Port Configuration
Protocol Enable: To enable or disable the port protocol
Edge: The port directly connected to end stations cannot create bridging loop
in the network. To configure the port as an edge port, mark the port
Path Cost: The cost of the path to the other bridge from this transmitting bridge
at the specified port. Enter a number 1 through 200000000
And then, click Apply to apply the configuration
Or, click Refresh to reset the configuration before applying
Spanning Tree Status
Click Refresh to get the newest configuration information. Also, the RSTP VLAN
Bridge information will display as below: