Transition Networks MIL-SW8T1GPA - Manual (Page 12)

10
Blinks Orange
Collision of Packets occurs in the
port
Off --
Half-duplex mode or no device
attached
On Green
The port is successfully connecting
with the device
Blinks Green
The port is receiving or transmitting
data
LNK /ACT
(MINI GBIC)
Off --
No data transmitted or no device
connected
The Description of LED Indicators
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The
surface where the switch locates should be clean, smooth, level and sturdy. Make
sure there is enough clearance around the switch to allow attachment of cables,
power cord and allow air circulation.
Attaching Rubber Pads
A. Make sure mounting surface on the bottom of the switch is grease and dust
free.
B. Remove adhesive backing from the Rubber Pads.
C. Apply the Rubber Pad to each corner on the bottom of the switch. These
footpads can prevent the switch from shock/vibration.
Power On
Connect the power adaptor to the power jag on the rear panel of the switch. The