Toshiba 27HL85 - Manual (Page 24)

24
(E)27HL85 size213*276
Setting up
y
our T
V
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
Adding channels to the TV’s memory
When you press Channel y or z, your TV will stop only on the
channels you program into the TV’s channel memory.
Follow the steps below and on the next page to program all active
channels into the TV’s memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in the channel memory. After the channels are
programmed automatically, you can manually add or erase individual
channels (see page 25).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z to highlight TV/CABLE.
3. Press x or • to select either TV (if you use an antenna) or
CABLE (if you use cable channels).
CH LABELING
ADD/ERASE
CH PROGRAM
TV/CABLE
LANGUAGE
SET UP
MENU BACK WATCH TV EXIT
ENGLISH
CABLE
ADD
VIDEO LABEL
ENTER
ENTER
1/2
4. Press z to select CH PROGRAM.
CH LABELING
ADD/ERASE
CH PROGRAM
TV/CABLE
LANGUAGE
SET UP
MENU BACK WATCH TV EXIT
ENGLISH
CABLE
ADD
VIDEO LABEL
ENTER
ENTER
1/2
5. Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
“Programming Now—Please Wait” appears.
6. When channel programming is complete, the message
“Completed” appears.
7. Press Channel y or z to view the programmed channels.
MENU
yzx •
Channel yz
1 2 3
4 5 6
7 8 9
ENT 100 0
POWER RECALL
CHRTN
FAV
FAV
TV / VIDEO
+10
PIC
SI
ZE
EXIT
INFO
STOP
POP DIRECT CH MUTE SLEEP
TV/VCR PAUSE
FF REW SKIP / SEARCH
SPLIT
SWAP POP CH
LIGHT REC
CH SCAN
FREEZE SOURCE
PLAY
TV
CBL/SAT
VCR
DVD
VOL CH
FAV
ORITE
ENTER
DVDMENU
MENU
TO
P ME NU GU ID E
CL
EA
R
E N TE
R ENTER
#01E22-25_27HL85 05.5.12, 3:14 PM 24
Black