Tech4o Alti-Ski - Manual (Page 9)

16 17
9.1 Altimeter Mode - Setting
• In altimeter mode, press and hold the [s/+] button for 2 seconds.
• The current altitude reading will flash.
• Using the [s/+] and [o/-] buttons, enter your reference altitude.
Your reference altitude should be obtained from a reliable map
source for your current altitude.
• Once you have researched and entered your reference altitude,
press the [o/o] button to confirm selection.
• The ft/m indicator will now flash.
• Press the [o/-] button to select your desired unit of measurement.
Press the [o/o] button to confirm selection.
• Altimeter mode also has an optional lock feature.
• Press the [o/o] button to lock altimeter mode and prevent any
accidental recordings of changes in altitude.
9.2 Altimeter Mode - Maximum Altitude
• In altimeter mode, press the [o/-] button to view the maximum
altitude.
• The maximum altitude is the highest altitude recorded since the
feature was last reset.
• To reset the maximum altitude, press and hold the [s/+] button for
2 seconds.
9.3 Altimeter Mode - Barometric Pressure
• In altimeter mode, press the [0/-] button to view the current
barometric pressure.
• To change the unit of measure, press and hold the [s/+] button for
2 seconds.
• The inHG / mbar indicator will flash.
• Use the [o/-] button to select your desired unit of measurement.
Press the [o/o] button to confirm your selection.
10.0 Descent Mode - Display
In descent mode, the watch will display
altitude descent measurements on the
top row and the current home time,
current temperature, or the run counter
on the second row depending on your
personal preference.
• To view descent mode, press the [m]
button until the mode indicator displays
the down arrow.