Toshiba W-608 - Manual (Page 41)

41
ADDITIONAL
INFORMA
TION
7 8
0 100
9
6 5
2 3
4
1
STOP
PLAY
FF REW
100
ENTER
POWER
CH/TRK
TV VOL
DISPLAY
I.SELECT
1
2, 3
Setting Control Codes
1 Press TV to set the remote control operating your TV.
2
3 Release PROG.
4 Point the remote control at your TV and use each button
listed below to make sure that your TV is operated correctly.
POWER To turn the TV on or off.
CH/TRK To select TV channels in the upper or lower
direction.
TV VOL To adjust the sound level.
I.SELECT To select an external source such as a VCR.
Number buttons To select TV channels. When selecting channels
1 to 9, first enter 0 and then the desired number.
100 To substitute for 100 channel key.
DISPLAY To turn on or off TV’s screen display.
ENTER To use for the TV’s ENTER key.
Important
Some TVs may not respond to all the operations above, or
may not be operated at all with this remote control. In this
case, operate your TV with its own remote control.
Notes
• For some brands, several control codes (brand codes) are allocated. Try
each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code again.
Multi Brand Remote Control
The remote control can be compatible with various brands of TV by setting their control codes. The
TOSHIBA code has initially been set to control TOSHIBA TVs.
ADDITIONAL INFORMATION
Number
buttons
While holding down PROG. enter the two digits of your TV’s
brand code (listed on page 42) using number buttons.
W-608/TSB (ENG) 1/17/01, 11:05 AM 41