Toshiba 32HL17 - Manual (Page 38)

38
HL17 (E/F) Web 213:276
Chapter 6: Using the TV’s features
Clearing channels from the History List:
• Reconfiguring the ANT input will clear the History List.
Note: See page 29 for details on configuring the antenna
input.
• Once 32 channels or inputs are stored in the History List, the
oldest item will be removed from the list when a new
channel or input is tuned.
• If History List in the Channel Browser Setup is set to
“Power Off Clear (On),” turning off the TV will clear the
History List.
Tuning to the next programmed channel
To tune to the next programmed channel:
Press < or , on the remote control or TV control panel.
Note:This feature will not work unless you program channels
into the TV’s channel memory (
- page 30).
Tuning to a specific channel (programmed
or unprogrammed)
Tuning analog channels:
Press the Channel Number (0–9) on the remote control. For
example, to select channel 125, press 1, 2, 5.
Tuning digital channels:
Press the Channel Number (0–9) on the remote control,
followed by the dash (
=) button and then the sub-channel
number. For example, to select digital channel 125-1, press 1,
2, 5, –, 1.
Note: If a digital channel is not programmed—either through
the automatic channel scan (
- page 30) or the channel add/
delete function ( - page 30)—you will have to tune the RF
channel using the Channel Number and dash ( = ) on the
remote control.
Switching between two channels using
Channel Return
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1
Select the first channel you want to view.
2
Select a second channel using the Channel Number
buttons (and the dash (
=) button if selecting a digital
channel).
3
Press R on the remote control. The previous channel
will display. Each time you press R, the TV will switch
back and forth between the last two channels that were
tuned.
Note: If you press R from a non-antenna input, the TV
will return to the last-viewed input.
Switching between two channels using
SurfLock
™
The SurfLock ™ feature temporarily “memorizes” one channel
to the R button, so you can return to that channel quickly
from any other channel by pressing R. To memorize a
channel to the R button:
1
Tune the TV to the channel you want to program into the
R button.
2
Press and hold R for about 2 seconds until the message
“Channel Memorized” appears on-screen. The channel
has been programmed to the
R button.
3
You can then change channels repeatedly, and when you
press
R, the memorized channel will be tuned.
The TV will return to the memorized channel one time only.
Once you press
R and then change channels again, the CH
RTN memory will be cleared and the button will function as
Channel Return, by switching back and forth between the last
two channels that are tuned. This feature also works for
external inputs.
32HL17_EN.book Page 38 Tuesday, April 24, 2007 11:06 AM