Step 5: attach belt clip to handset (optional), Step 6: install handset battery pack, Step 5: attach belt clip to handset (optional) – Toshiba STRATA CTX DKT2004-CT User Manual
Page 25: Step 6: install handset battery pack
Installation
Step 5: Attach Belt Clip to Handset (optional)
Strata DKT2004-CT Cordless Digital Telephone 10/02
13
Step 5: Attach Belt Clip to Handset
(optional)
➤
To attach the belt clip to the handset
1. Snap the tabs of the belt clip into the notches
on the sides of the handset.
2. Use the belt clip to attach the handset to your
belt or pocket for convenient portability.
➤
To remove the belt clip
1. Pry one tab at a time from the notch on the side of the handset.
2. Carefully lift the belt clip off.
Note
The belt clip is designed to fit snugly onto the handset.
Step 6: Install Handset Battery Pack
1. Place a charged battery pack onto the handset so that it slides
easily along the ridges.
If your battery is not charged, see
.
2. Slide the battery pack up onto the handset until it clicks into
place.
You are now ready to configure your cordless digital telephone.
See “Configuration” on page 17.
Important!
Before using your new cordless phone, the battery
must be charged continuously for 10 hours.
Lanyard Clip
R/VOL
MUTE
s
s
1160
1155